| 1. |
Remove the engine cover.
|
| 2. |
Remove the battery terminal.
|
| 3. |
Remove the air duct.
|
| 4. |
Remove the battery tray.
|
| 5. |
Remove the air cleaner.
| (1) |
Upper
|
| (2) |
Lower
| |
| 6. |
After removing the CKP sensor, O2 sensor and
oil pressure switch wiring bracket, separate the
connectors.
|
| 7. |
Remove the speedometer sensor
connector. |
| 8. |
Remove the transaxle range
switch.
|
| 9. |
Remove the oil cooler hose.
|
| 10. |
Remove the clip(transaxle side) of the shift
cable.
|
| 11. |
Separate the steering column shaft
joint.
|
| 12. |
Separate the power steering oil pump
hose.
|
Be careful not to leak after
separating. | |
| 13. |
Separate the hose after removing the clip of
the power steering return hose.
|
| 14. |
Remove the upper connecting transaxle
bolt.
|
| 15. |
Separate the start motor.
|
| 16. |
Install the engine support
fixture. |
| 17. |
After removing the tire, remove the
caliper.
|
| 18. |
Remove the transaxle side cover.
|
| 19. |
Remove the transaxle under cover.
|
| 20. |
Separate the tie rod end.
|
| 21. |
Remove the wheel speed sensor and the knuckle
mounting bolt.
|
| 22. |
Drain the oil.
|
| 23. |
Remove the transaxle mounting
bracket.
| (1) |
Insulator bolt
|
| (2) |
Body mounting bolt (Upper)
|
| (3) |
Body mounting bolt (Side)
|
| (4) |
Transaxle side mounting
bolt
| |
| 24. |
Remove the front roll stopper.
| (1) |
Insulator bolt
|
| (2) |
Stopper bolt (Upper)
|
| (3) |
Stopper bolt (Lower)
| |
| 25. |
Remove the rear roll stopper.
| (1) |
Insulator bolt
|
| (2) |
Stopper bolt
| |
| 26. |
Remove the drive
shaft. |
| 27. |
Remove the front muffler.
|
| 28. |
Remove the sub frame mounting
bolt.
|
| 29. |
Install the jack under the transaxle
assembly.
|
| 30. |
Remove the transaxle lower mounting bolt to
the engine.
|
| 31. |
Remove the transaxle
assembly. |
| 1. |
Attach the torque converter on the transaxle
side and mount the transaxle assembly onto the engine.
|
If the torque converter is mounted first
on the engine, the oil seal on the transaxle may be damaged.
Therefore, first be sure to assemble the torque converter to
the
transaxle. | |
| 2. |
Install the transaxle control cable and adjust
as follows:
| (1) |
Move the shift lever and the transaxle
range switch to the "N" position and install the control
cable. |
| (2) |
When connecting the control cable to the
transaxle mounting bracket, install the clip until it contacts
to the control cable. |
| (3) |
Remove any free-play in the control
cable by adjusting the nut and then check to see that the
selected lever moves
smoothly. |
| (4) |
Check to see that the control cable has
been adjusted
correctly. | | |
